Logo

C1518 Engine Code Repair

Meaning of C1518 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C1518 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C1518 code is occuring now you should check C1518 repair processes.
Now don't ask yourself; What should you do with C1518 code ?
The solution is here :

C1518 Possible Solution:

C1518 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

C1518 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

1
Fuel And Air Metering

5
O2 Sensor Heater Circuit Malfunction

1
Cold Start Injector 1 Malfunction

8
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

Regarding the C1518 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C1518 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1518 engine trouble code is about Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical.

Main reason For C1518 Code

The reason of C1518 OBD-II Engine Trouble Code is O2 Sensor Heater Circuit Malfunction.

C1518 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.